Moving Targets and Tracking Without Chase Corrections
The usual tracking failure is not losing sight of the target. It is falling behind, accelerating too hard, passing it, and pulling back like you are chasing a car that has already gone by. Train speed matching instead.
Match the target’s speed
On a steady target, catch up, overlap briefly, then maintain a similar speed. The hand should move continuously instead of stopping every few pixels to re-aim.
If the crosshair stays behind the target, do not yank it forward. Split the catch-up into a smaller movement. Large corrections usually create the next overshoot.
Read direction changes
A small delay at a reversal is normal. The bigger issue is waiting until the target has gone far away before reversing. Notice slowing, pausing or turning cues and let the hand decelerate early.
This is not guessing a location. It reduces momentum in the hand, so the reversal does not require one large pull back.
Using the trail toggle
With trail display on, look only at the most recent 0.5 seconds near the crosshair. A smooth short line usually means speed matching; saw teeth and large back-and-forth arcs show chasing. The trail is for understanding the latest correction, not for staring at a full history.
Three signs of progress
- The crosshair spends longer close to the center of the target.
- Direction changes need fewer second corrections.
- Average reaction and variation are steadier at the same accuracy.
Moving Target versus Tracking
Moving Target is a good start for speed matching. Tracking asks you to hold the crosshair on the target and reveals reversals more clearly. Reduce large swings in Moving Target before extending time in Tracking.